Notes
Flame Test Wire
A small piece of inert metal wire is bent into a
loop to support a small drop of solution. The
small loop is dipped into a solution, and then
the wire loop is placed into the outer flame.
Flame test wires can easily become
contaminated. Make sure your wire is clean
before trying to observe new solutions. You
can clean your wire by dipping it into HCl and
then placing it in the flame. If it is clean,
there will not be a large color change when
the wire is placed in the flame.
Record your flame test observations for
each of these solutions.
Potassium Chloride, Calcium Chloride, Strontium Chloride, Sodium
Chloride, Copper Chloride, Lithium Chloride
Safety Considerations
Strong acids and bases are used in this laboratory along with toxic metals.Make
sure to wash hands immediately if you come in contact with these materials.
Bunsen burners should be treated with care to avoid fires and burns.
Waste Disposal
All generated waste should be placed in a labeled waste container.
40
Figure 4.2: Flame Tests is shared under a
CC BY-NC-SA 4.0 license and was authored,
remixed, and/or curated by LibreTexts.